Configuration; Figure B-3. Cli Help And Help Snmp Commands - StorageTek L700 Service Manual

Configuration

Configuration
There are three ways to configure the library to support SNMP:
1. Library Admin, an optional feature for the library, but it is not required to
support SNMP.
2. The CLI port (command line interface)
See
3. The SNMP software application—you can also use any SNMP application to change
some of the agent's settings. You must be MIB-aware and refer to the L-series.mib for
specific information.

Figure B-3. CLI Help and Help SNMP Commands

cli> help
help [command]
diag
download
fsc
network
snmp
time
password
cli> help snmp
snmp view
snmp community [string]
snmp [enable|disable]
snmp port [port number]
snmp grace [number]
snmp reset
snmp list
snmp add
snmp add [ipaddr|name]
snmp add [ipaddr|name] [host port number]
snmp delete [[ipaddr|name] [host port number]] | all
cli> _
B-6
Figure B-3 for examples of the help and help snmp commands
help on a specific command
execute diagnostics
download new image to prom
manipulate fault symptom codes
manipulate network information
manipulate SNMP configuration
view/modify library date & time
reset/modify library admin password
display SNMP Agent settings
set Community String/IP address
enable of disable SNMP Agent
set Agent Listening Port Number
(Valid: 161, 1024-65535)
set Write Grace Period Number
( 1-5 minutes )
set SNMP Agent configuration parameters
to default values
display SNMP Trap Recipient List
add a member to the SNMP Trap Recipient List by
answering individual prompts for values.
add a member to the SNMP Trap Recipient List using
some default values
add a member to the SNMP Trap Recipient List
using some default values
delete all or a selected member of the SNMP
Trap Recipient List
Where valid [host port number] values: (162, 1024-65535)
Fourteenth Edition
StorageTek Proprietary
95846