Setting The Library's Scsi Id - StorageTek L700 Service Manual

3. Date
4. Time
Note: The procedures below assume that you will make all entries during one, operator

Setting the Library's SCSI ID

If the control path for the library is SCSI, you must enter the library's SCSI ID at the
operator panel from the Lib SCSI I/F Config Menu.
Note: The information below explains special circumstances for selecting a SCSI ID
•
•
•
•
•
•
To set the library's SCSI ID:
1. From the online status screen, press the
The Main Menu will display.
2. Press the down arrow button until the cursor underscores CONFIGURATION.
3. Press the
The Main Configuration Menu will appear and the cursor will line up with
LIBRARY CONFIG.
95846
panel entry session. Each item is saved as it is changed, except for the library's
SCSI ID or Fibre Channel Port 0 address: to save a revised library SCSI ID, you
must reset the library by pressing the
(address) for the library:
When configuring the library to a Unix-based workstation, StorageTek
recommends that you use a dedicated SCSI client host bus adapter (HBA):
- For wide SCSI adapters, you may assign any address from 0 to 14 for
the library.
- For narrow SCSI adapters, the range of addresses is 0 to 6.
If you choose to use the embedded system bus on the SPARC station, select
address 6, 5, 2, or 0 for the library; the remaining targets are reserved for Sun
peripherals.
For IBM RISC System/6000 machines, available addresses on the embedded
system bus are 6, 5, 3, and 2.
If the customer is using Automated Cartridge System Library Software (ACSLS),
its level must be Version 5.3.2 or later
If the library contains a PTP, the ACSLS level must be Version 6.0 or later and
contain the special program enhancement for PTP operation.
If the library contains T9840B drives running on ESCON channels, the ACSLS
level must be Version 6.0.1 or later.
button.
SELECT
Fourteenth Edition
StorageTek Proprietary
Operator Panel Entry
button.
RESET
button.
MENU
2-23