CAUTION:
Possible equipment damage: When sliding the tape drive into its slot, make sure the
drive SCSI cable is out of the way. Do not force the drive into the slot.
6. Slide the drive into its slot, being careful not to catch or crush any cables.
7. Tighten the thumbscrew on the left side of the drive.
8. Connect the SCSI cable screw locks to the SCSI connector on the rear of the drive.
9. Turn on the drive power by placing the switch to the on (|) position.
10. Close the right side door of the library.
3
2
11. Return the system to operation. See
95846
1. Cable clamp
2. SCSI cable screw locks
3. Thumbscrew
1
C65224
"Restoring Library Operation" on page
Fourteenth Edition
StorageTek Proprietary
Tape Drive Components
5-140.
5-99