StorageTek L700 Service Manual page 217

Ne remettez pas l'ensemble de porte-lecteurs sous tension s'il n'est pas
installé dans la bibliothèque.
1. Review the information under
2. Open the right side door of the tape library.
3. Turn of the power to the drive by placing the switch in the off (O) position.
4. Release the cable from the cable clamp.
5. Carefully remove the SCSI cable from the rear of the drive by unscrewing the two SCSI cable screw
locks.
6. Loosen the thumbscrew on the left side of the DLT drive.
3
2
7. Using a Torx T-15 driver, remove the five power supply cover screws.
1
95846
"Preparation" on page 5-1
1. Cable clamp
2. SCSI cable screw locks
3. Thumbscrew
1
C65224
1. Power supply cover screws
E65220
Fourteenth Edition
StorageTek Proprietary
Tape Drive Components
and "DLT Preparation" on page 5-69.
5-77