Tape Drive Components
Replacement
1. Set the drive on a flat work surface
2. Slide the drive tray over the drive.
3. Using a Torx T-10 driver, attach the four screws on the bottom of the drive tray.
1
4. Remove any jumpers from the rear of the defective drive and place them in the same locations on
the replacement drive.
5. Attach the SCSI cable, power connector, and TTI cable to the drive.
Seagate
3
5-104
2
C65328
2
1
C65327
Fourteenth Edition
StorageTek Proprietary
1. Drive tray screw (4X)
2. Drive tray bottom
1. SCSI cable
2. Power connector
3. TTI cable
95846