StorageTek L700 Service Manual page 156

Hand-Camera Assembly
CAUTION:
Possible equipment damage: If the shipping pin is not available, make sure to hold
on to the Z belt when removing the hand-camera assembly. The Z carriage could be
damaged if it is not held in place.
5. Carefully lower the Z carriage to the middle of the Z column assembly, rotate the Z column until
the hand-camera is facing Column 0, Panel 0, and insert the shipping pin left to right through the Z
column into the Z carriage.
6. Remove the Torx T-15 lower hand-camera assembly screw from behind the hand-camera.
2
7. Rotate the Z column clockwise as far as possible and remove the second Torx T-15 lower screw.
1
5-16
1. Shipping pin
2. Bottom screw
1
E65094
1. Lower hand-camera screw
C65093
Fourteenth Edition
StorageTek Proprietary
95846