StorageTek L700 Service Manual page 233

Tape library and l700-pass-thru port
Hide thumbs Also See for L700:
Table of Contents

Advertisement

5. Using a Torx T-15 driver, attach the five power supply cover screws.
1
CAUTION:
Possible equipment damage: When sliding the tape drive into its slot, make sure the
drive SCSI cable is out of the way. Do not force the drive into the slot.
6. Slide the drive into its slot, being careful not to catch or crush any cables.
7. Tighten the thumbscrew on the left side of the drive.
8. Connect the SCSI cable screw locks to the SCSI connector on the rear of the drive.
9. Turn on the drive power by placing the switch to the on (|) position.
10. Close the right side door of the library.
3
2
11. Return the system to operation. See
95846
1. Power supply screws
C65321
1. Cable clamp
2. SCSI cable screw locks
3. Thumbscrew
1
C65224
"Restoring Library Operation" on page
Fourteenth Edition
StorageTek Proprietary
Tape Drive Components
5-140.
5-93

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

700e

Table of Contents