StorageTek L700 Service Manual page 220

Tape Drive Components
3. Using a Torx T-15 driver, attach the five power supply cover screws.
1
CAUTION:
Possible equipment damage: When sliding the tape drive into its slot, make sure the
drive SCSI cable is out of the way. Do not force the drive into the slot.
4. Slide the drive into its slot, being careful not to catch or crush any cables.
5. Tighten the thumbscrew on the left side of the DLT drive.
6. Connect the SCSI cable screw locks to the SCSI connector on the rear of the drive.
7. Insert and secure the cable through the cable clamp.
8. Turn on the drive power by placing the switch to the on (|) position.
9. Close the right side door of the library.
3
2
10. Return the system to operation. See
5-80
1. Power supply screws
E65220
1. Cable clamp
2. SCSI cable screw locks
3. Thumbscrew
1
C65224
"Restoring Library Operation" on page
Fourteenth Edition
StorageTek Proprietary
5-140.
95846