10. Turn the drive tray over to access the four screws on the bottom of the drive tray. Using a Torx T-10
driver, remove the four drive screws.
11. Lift and remove the drive tray.
1
Replacement
1. Set the drive on a flat work surface
2. Slide the drive tray over the drive.
3. Using a Torx T-10 driver, attach the four screws on the bottom of the drive tray.
1
4. Remove any jumpers from the rear of the defective drive and place them in the same locations on
the replacement drive.
95846
1. Drive tray screw (4X)
2. Drive tray bottom
2
C65362
1. Drive tray screw (4X)
2
C65362
Fourteenth Edition
StorageTek Proprietary
Tape Drive Components
5-109