T9X40 Tape Drive - StorageTek L700 Service Manual

4. Slide the clamp-shell into the SCSI connector and connect the SCSI Y cable by screwing in the two
screw locks on the clamp-shell.
2
5. Return the system to operation. See

T9x40 Tape Drive

Refer to the T9x40 Service Reference Manual for information on removing and replacing
T9x40-related FRUs.
Note: If the T9x40 drive is connected to a Fibre channel and the library is operating
CAUTION:
System configuration problems: When adding or replacing a drive,
always check and, if necessary, configure the drive's SCSI ID at the
library's operator panel.
95846
1
C65184
"Restoring Library Operation" on page
with dynamic world-wide name (dWWN) enabled, refer to
Removal/Replacement when dWWN Enabled" on page 5-67
to remove/replace the drive.
Fourteenth Edition
StorageTek Proprietary
1. Cable clamp
2. SCSI cable screw locks
Tape Drive Components
5-140.
"Tape Drive
before attempting
5-115