Removal - StorageTek L700 Service Manual

Tape Drive Components

Removal

1. Review the information under
2. Open the right side door of the tape library.
3. Turn off the power to the drive by placing the switch in the off (O) position.
4. Carefully remove the SCSI cable from the rear of the drive by unscrewing the two SCSI cable screw
locks.
5. Loosen the thumbscrew on the left side of the drive.
3
2
6. Grip the rear of the drive and, while pulling it toward you, place your other hand under the drive
tray for support.
7. Using both hands, remove the drive tray assembly from the slot, and place it on a flat, stable surface.
8. Using a Torx T-15 driver, remove the five power supply cover screws.
1
5-90
"Preparation" on page 5-1.
1. Cable clamp
2. SCSI cable screw locks
3. Thumbscrew
1
C65224
1. Power supply cover screws
C65321
Fourteenth Edition
StorageTek Proprietary
95846