Cartridge Access Port (CAP) Components
Replacement
1. Install the new CAP motor and, using a needle-nose pliers, attach two springs below the CAP
motor. Be sure the CAP belt is placed on the CAP motor pulley and centered in the top channel.
1
2. Connect the CAP motor cable connector.
3. Replace the cables in the cable clamp
4. Use a Torx T-25 screw to attach the cable clamp to the CAP motor bracket.
5. Attach the two CAP motor screws using a Torx T-15 driver.
4
6. Return the system to operation. See
5-6
2
C65096
1
2
3
E65097
"Restoring Library Operation" on page
Fourteenth Edition
StorageTek Proprietary
1. CAP belt
2. CAP motor springs
1. CAP motor cable connector
2. CAP motor
3. CAP motor screws
4. Cable clamp screw
5-140.
95846