Importing Cleaning Cartridges Through The Cap - StorageTek L700 Service Manual

Auto Clean

Importing Cleaning Cartridges through the CAP

A second way to enable Auto Clean is by importing cleaning cartridges from the CAP
into the reserved cells, the procedure is to:
1. Press the
2. Press the arrow buttons until the cursor underscores CLEANING INFORMATION.
3. Press the
The panel displays the Cleaning Info menu.
4. Press the arrow buttons until the cursor underscores IMPORT CARTRIDGE.
5. Press the
The Import Clean Cartridges screen appears, which prompts you to:
•
•
CAUTION:
Possible halt to operation or damage to components. You must enter the
cartridges properly or you could damage the robot or the drive, or cause
the library to stop operating. Use only the correct cartridges for the drive
types within the library.
6. Load cartridges into the magazine. You can do this one of two ways:
a. Pull out and down on the magazine handle
b. Remove the magazine by lifting it out
CAUTION:
Possible damage to the hand assembly. Before loading the magazine
into the CAP, remove the magazine's retention cover by lifting the side
edge.
7. Enter the cartridges into the magazine so that the cartridges lie flat, with the
VOLSER label facing toward you, the customer label facing down, and the reel
facing away from you.
8. Return the magazine to its closed position. (If you have used a retention cover on the
magazine, remove the cover before replacing the magazine.)
9. Press the
The cleaning cartridges are audited by the robot and their types and VOLSERs are
listed on the operator panel. You must now select each cartridge at the operator
panel to import it into the library.
10. Select the cleaning cartridges you want to import by:
2-42
button to return to the Main Menu.
MENU
button.
SELECT
button.
SELECT
Enter only cleaning cartridges—no data cartridges are allowed
Enter the cleaning cartridges into CAP A only
button on the operator panel to close the CAP.
SELECT
Fourteenth Edition
StorageTek Proprietary
95846