Loading Paper In Tray 5 (Bypass) - Fuji Xerox DocuCentre SC2020 User Manual

Important • While the machine is copying or printing, do not
2
For Tray 1, push down the metal plate.
3
Load paper with the side to copy or print on
facing up. Align the leading edge of paper with
the left side of the tray.
Important • Do not load paper above the maximum fill line .
4
Push the tray in gently until it stops.
Important • When pushing the tray in, do it slowly. If the tray is pushed with too much force, it may cause

Loading Paper in Tray 5 (bypass)

When printing or copying on paper that cannot be set in Trays 1 and 2, use the Tray 5
(bypass). The following describes the procedure for loading paper into the Tray 5 (bypass).
For printing, specify the settings on the [Paper/Output] tab using the print driver. Also
specify the type of paper to be loaded.
Important • To prevent paper jams or loading errors, do not remove paper from its packaging until needed.
Note
1
Open the Tray 5 (bypass).
Note
pull out the tray that the job uses.
• To prevent paper jams or loading errors, do not
load different sizes or types of paper on top of
any remaining paper in a tray.
• Pulling out all the trays at once may cause the
machine to tilt or fall, causing injury.
It may cause paper jams or machine
malfunctions.
• Do not place any paper or objects in the empty
space on the right side of Trays 1 and 2. It may
cause paper jams or machine malfunction.
machine malfunctions.
• Fan the stack of paper well before loading paper in a tray. It prevents paper from sticking to each
other and reduces paper jams.
• If necessary, pull out the extension tray. Pull out
the extension tray gently.
Loading Paper
4
65