Fuji Xerox DocuCentre SC2020 User Manual page 158

9 Tools
Gateway Address
Note
Disable
Note
Auto
10BASE-T Half
10BASE-T Full
100BASE-TX Half
100BASE-TX Full
9
Protocols
Purpose:
To enable or disable each protocol. The change becomes effective after the machine is
turned off and then on again.
Values:
LPD
Port9100
FTP
IPP
WSD Print
158
IPsec
• IPsec feature is available only when IPsec is enabled on CentreWare Internet Services.
Purpose:
Disables IPsec.
Value:
Connection Speed
• Connection Speed feature is available only when the machine is connected using the network.
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change
becomes effective after the machine is turned off and then on again.
Values:
Disable
Enable
Disable
Enable
Disable
Enable
Disable
Enable
Disable
Enable
When an IP address is being set manually, the
gateway address is specified using the format
"nnn.nnn.nnn.nnn". Each octet that makes up
"nnn.nnn.nnn.nnn" is a value in the range of
"0" to "254. 127" and any value in the range
of "224" to "254" cannot be specified for the
first octet of a gateway address.
Disables IPsec.
Detects the Ethernet settings automatically.
Uses 10BASE-T Half-duplex.
Uses 10BASE-T Full-duplex.
Uses 100BASE-TX Half-duplex.
Uses 100BASE-TX Full-duplex.
Disables the Line Printer Daemon (LPD) port.
Enables the LPD port.
Disables the Port9100 port.
Enables the Port9100 port.
Disables FTP port.
Enables FTP port.
Disables IPP port.
Enables IPP port.
Disables WSD print.
Enables WSD print.