Power Saver Modes; Entering Power Saver Modes; Exiting Power Saver Modes - Fuji Xerox DocuCentre SC2020 User Manual

Power Saver Modes

The machine is installed with the Power Saver function that will automatically cut off the
electricity to the machine if no copy or print data is received for a certain duration.
There are two Power Saver modes: Low Power mode and Sleep mode.
Low Power Mode
The machine's power is not turned OFF completely in Low Power mode. Instead, this mode
creates a balance between low power consumption and short warm-up time by controlling
the temperature of the fusing unit to a level midway between the power OFF temperature
and the "Ready" temperature.
Sleep Mode
Sleep mode minimizes power consumption by shutting off the power to all components
except the controller. Warm-up time in Sleep mode is longer than in Low Power mode.

Entering Power Saver Modes

The display goes off, and the <Power Saver> button
of the control panel lights up when the machine is in
an Power Saver mode.
You can set the length of time to wait until the
machine enters Low Power/Sleep mode.
Low Power mode is set to 1 minutes and Sleep mode
to 0 minutes as default.
You can set the amount of time the machine waits
before entering Low Power mode from 1 to 150
minutes, and the amount of time the machine waits before entering Sleep mode from 0 to
60 minutes.
Important • The fusing unit life is largely influenced by power distribution time on the machine. Setting the
For more information on how to set the time interval for Low Power mode and/or Sleep mode, refer to "Power Saver" (P.169).

Exiting Power Saver Modes

The following describes how to deactivate Power Saver mode.
The machine exits Power Saver mode in the following conditions:
Note
Pressing the <Power Saver> button
Pop-up on the touch screen by pulling out and putting in Tray 1
Detecting a machine error
Rebooting the machine
Receiving a job
amount of time the machine waits before activating the Power Saver function to a long value will
keep the machine's power on longer, and the fusing unit may have to be replaced more often. It
may cause an early replacement of the fusing unit of the machine. For more information, contact
our Customer Support Center.
• After exiting Power Saver mode in some conditions, the machine keeps the touch screen turned off
to save power. The touch screen lights up when the condition with an asterisk is met.
*
*

Power Saver Modes

<Power Saver> button
Redial/Pause Power Saver
Clear All Stop
Start
Error
Data
*
51
3