Rep 4.0.7 Process Drive - Xerox Phaser 8560MFP Service Documentation

REP 4.0.7 Process Drive

Parts List on PL 4.0
Removal
If the Process Drive is being reinstalled, pin the gears using the holes provided in the Process
Drive frame (Figure 1) to maintain gear alignment. Use a paper clip or similar object to pin the
gears before removing the drive. Replacement drives have pins installed. Do not remove these
pins until the drive has been installed. Installation of the Process Drive with misaligned gears
can damage the system. See Figure 1 to verify proper gear position before replacing the
screws.
Before installing the Process Drive, use ADJ 2.2.1 and ADJ 2.5.1 to put the Printhead and
Wiper Assembly in the home position.
Seat all 3 mounting screws before torquing the screws to final tightness (12 in-lbs.). Tightening
the screws individually before seating all three can put undue strain on the mounting bosses.
1. Remove the Scanner Assembly with attached DADF (REP 1.0.11).
2. Remove the Output Tray (REP 1.0.6).
3. Remove the Right Side Cover (REP 1.0.21).
4. Pin the Process Drive gears, if the drive is being reinstalled, using paper clips or similar
objects.
5. Disconnect the Drum Heater (P/J200) from the Relay Board and remove it.
6. Release the Drum Encoder and Drum Fan wiring from the Process Drive wiring retainers
7. Remove 3 (plastic, T-20) screws that secure the Process Drive to the chassis.
Initial Issue
Phaser 8510/8560MFP Multifunction Product
CAUTION
CAUTION
CAUTION
Figure 1 Removing the Process Drive and Process Drive Gear Alignment
8. Remove the Process Drive from the chassis.
9. Disconnect the Process Drive from the harness.
Replacement
Perform the Head Tilt Gear (ADJ 4.13.1), and Process Drive Alignment (ADJ 4.7.1) adjust-
ments before restoring system power.
10/2006
4-47
Repairs and Adjustments
REP 4.0.7