Rep 3.0.2 Lower Duplex Guide; Rep 3.0.3 Take Away Roller - Xerox Phaser 8560MFP Service Documentation

REP 3.0.2 Lower Duplex Guide

Parts List on PL 3.0
Removal
1. Open the Front Door.
2. Pull outward on the tabs at the bottom of the guide and let the guide swing free.
3. Pry inward, towards the center of the printer, on the right, upper retainer to release it from
the boss and remove the guide.
Figure 1 Removing the Lower Duplex Guide
Initial Issue
Phaser 8510/8560MFP Multifunction Product

REP 3.0.3 Take Away Roller

Parts List on PL 3.0
Removal
1. Remove the Front Door (REP 1.0.1).
2. Remove the Scanner Assembly with attached DADF (REP 1.0.11).
3. Remove the Output Tray (REP 1.0.6).
4. Remove the Right Side Cover (REP 1.0.21).
5. Remove the Left Side Cover (REP 1.0.7).
6. Remove the Media Drive Assembly (REP 4.0.14).
7. Remove the Inner Simplex Guide (REP 3.0.1).
8. Remove the KL-Clip from the right end of the Take Away Roller shaft.
9. Remove the KL-Clip and bushing from the left end of the shaft. Slide the shaft to the left to
release the right end from the chassis. Rotate the shaft forward, and then remove it to the
right.
NOTE: Pressure from the Idler Rollers may make it difficult to slide the Take Away Roller
shaft to the right during removal.
Figure 1 Removing the Take Away Roller
10/2006
4-39
Repairs and Adjustments
REP 3.0.2, REP 3.0.3