Xerox Phaser 8560MFP Service Documentation page 214

Print Engine Exercise Menu
This submenu contains a group of functions intended to stimulate a specific portion of the print
engine system in such a way that the test can be observed. Listening observations may be
required for certain tests and will prompt you on the control panel if covers, doors, or trays need
to be removed.
Table 5 Print Engine Exercise Menu Definitions
Test Description
Activators Menu The tests pulse the specified target causing it to generate a
• Exercise All sound or motion. The Exercise All function cycles each of the
listed components below 4 times, in sequence, until interrupted
• Tray 1 Pick Solenoid
by pressing the Cancel button. The other functions continue
• Tray 2 Pick Clutch
cycling repeatedly until interrupted by a control panel key
• Tray 3 Pick Clutch
press. The Cancel button should be pressed only when the
• Tray 4 Pick Clutch
state is Off
• Deskew Clutch
• Strip Solenoid
• Head Maintenance
Clutch
• Purge Vent Solenoid
• Drum Heater Relay
Diagnostics
Service Diagnostics
Table 5 Print Engine Exercise Menu Definitions
Test Description
Motor/Shafts Menu The motor and shaft functions drive the specified motor or shaft
• Exercise All enough to generate enough motion to be easily observed (usu-
ally 1 revolution), without making a substantial change to the
• Process Motor
state of the system.The Exercise All function cycles each of the
• Y-axis Motor
listed motors/shafts 3 times in sequence until interrupted by a
• X-axis Motor
control panel button press. The other functions continue to
• Purge Pump Motor
cycle the motor/shaft repeatedly until interrupted by a control
• Drum Fan Motor panel key press.
• Electronics Fan Motor
• Media Path Motor &
Shafts
• Transfix Cam Shaft
• Drum Maintenance
Cam Shaft
• Deskew Shaft
• Wiper Shaft
• Tray 1 Pick Shaft
• Tray 2 Pick Shaft
• Tray 3 Pick Shaft
• Tray 0 lift motor
• Tray 3 Lift Motor
• Tray 3 Motor & Shafts
• Tray 4 Pick Shaft
• Tray 4 Lift Motor
• Tray 4 Motor & Shafts
Heaters Menu Allows the heaters to be forced to an On or Off condition or to
• Monitor Heaters be toggled from one condition to the other. Also provides moni-
toring to observe the resulting heater power or temperature.
• Monitor Temperatures
• All Heaters On (warm-
up to normal operating
temperature setpoints
with Ink Melt Heaters
Off).
• All Heaters Off
• Toggle Printhead Heat-
ers
• Toggle Preheat Heater
• Toggle Drum Heater
• Toggle Ink Melt Heaters
(The Ink Melt Heaters
remain On for 4 sec-
onds.).
10/2006
6-12
Initial Issue
Phaser 8510/8560MFP Multifunction Product