Symbology And Nomenclature - Xerox Phaser 8560MFP Service Documentation

Symbology and Nomenclature

The following reference symbols are used throughout the documentation.
Warnings, Cautions, and Notes
Warnings, Cautions, and Notes will be found throughout the Service Documentation. The
words WARNING or CAUTION may be listed on an illustration when the specific component
associated with the potential hazard is pointed out; however, the message of the WARNING or
CAUTION is always located in the text. Their definitions are as follows:
A Warning is used whenever an operating or maintenance procedure, a practice, condi-
tion, or statement, if not strictly observed, could result in personal injury.
A Caution is used whenever an operating or maintenance procedure, a practice, condition, or
statement, if not strictly observed, could result in damage to the equipment.
NOTE: A Note is used whenever it is necessary to highlight an operating or maintenance pro-
cedure, practice, condition, or statement.
Common Warnings and Safety Icons
The following common warnings are used throughout the documentation and the safety icons
are displayed on the machine. Additional specific warnings are included for the listed sections.
Common Warnings
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
DANGER: Afin d'éviter des blessures ou des chocs électriques, ne pas effectuer des
activités de maintenance ou de réglage avec l'équipement sur Marche ou avec le cordon
d'alimentation branché.
The following sections have additional specific warning information.
Table 1 Introduction and Section 4
Introduction - Symbology and Nomenclature
Section 4 - Repairs and Adjustments
A Warning is used whenever an operating or maintenance procedure, a practice, condi-
tioning, or statement, if not strictly observed, could result in personal injury.
DANGER: Une note DANGER est utilisée à chaque fois qu'une procédure de mainte-
nance ou qu'une manipulation présente un risque de blessure si elle n'a pas été stricte-
ment observée.
The following sections have additional specific warning information.
Table 2 Additional Warnings
REP 2.0.2 Print head Assembly
REP 2.0.8 Left and Right Printhead Restraints
Initial Issue
Phaser 8510/8560MFP Multifunction Product
WARNING
CAUTION
WARNING
WARNING
Table 2 Additional Warnings
REP 5.0.2 Scanner Power Supply
REP 5.0.19 Drum Heater Relay Board
HIGH VOLTAGE!
DANGER: HAUTE TENSION!
Exercise care when making the voltage check in the following steps.
DANGER: Soyez extrêmement vigilant lorsque vous effectuez les tests de tension au
cours des étapes qui suivent.
Personal injury may result from grasping hot areas of Printhead. If a hot Printhead must
be removed, grasp the Printhead by black plastic frame component.
DANGER: Des blessures peuvent résulter si les zones chaudes du module de four sont
touchées. Si un module de four chaud doit être enlevé, le saisir par l'élément en plas-
tique noir du bâti.
Machine Safety Icons
The following precautionary symbols may appear on the system.
This symbol indicates DANGER high voltage.
Figure 1 High Voltage Symbol
Protective ground (earth) symbol.
Figure 2 Protective Ground (earth) Symbol
These symbols indicate hot surface on or in the printer. Use caution to avoid personal injury.
Figure 3 Hot Surface Symbol
10/2006
ix
WARNING
WARNING
Symbology and Nomenclature
Introduction