REP 4.0.3 Scanner Power Supply Fan
Parts List on PL 4.0
Removal
1.
Remove the Scanner Assembly with attached DADF (REP 1.0.11).
2.
Remove the Output Tray (REP 1.0.6).
3.
Remove the Left Side Cover (REP 1.0.7).
4.
Remove the Right Side Cover (REP 1.0.21).
5.
Remove the Rear Cover (REP 1.0.20).
6.
Disconnect the fan connector (CN5) from the Exit Module Control Board.
7.
Remove 2 (plastic, T-20) screws that secure the fan to the frame.
Figure 1 Removing the Scanner Power Supply Fan
Replacement
NOTE: Route the fan harness behind the mylar insulator as shown in Figure 1.
Initial Issue
Phaser 8510/8560MFP Multifunction Product
REP 4.0.4 Head Maintenance Clutch
Parts List on PL 4.0
Removal
1.
Remove the Scanner Assembly with attached DADF (REP 1.0.11).
2.
Remove the Output Tray (REP 1.0.6).
3.
Remove the Right Side Cover (REP 1.0.21).
4.
Disconnect the Head Maintenance Clutch (P/J130) from the harness.
5.
Remove the KL-Clip that secures the Wiper Clutch to the shaft and remove the clutch.
Figure 1 Removing the Head Maintenance Clutch
Replacement
Perform the Head Tilt Gear (ADJ 4.13.1), and Process Drive Alignment (ADJ 4.7.1) adjust-
ments before restoring system power.
10/2006
4-45
Repairs and Adjustments
REP 4.0.3, REP 4.0.4