23,0Xx.6X Nvram Faults; 26,0Xx.6X Printing Faults - Xerox Phaser 8560MFP Service Documentation

23,0XX.6x NVRAM Faults

An NVRAM error has occurred. The following troubleshooting procedure applies to these
errors:
NVRAM Faults
23,0xx.6x The system detected an NVRAM fault during operation.
Initial Actions
• Reset NVRAM and retest.
• If the problem persists, follow the procedure below.
Primary Causes
The troubleshooting table lists parts and wiring referenced in the troubleshooting procedure.
Table 1 23,0XX.6x Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack References
NVRAM, PL 5.0
Troubleshooting Procedure
Table 2 X-Axis Program Faults Troubleshooting Procedure
Step Questions or Actions
1 Reseat all Electronics Module connec-
tions.
Does the problem persist?
2 Check ground integrity.
Are the system grounds connected?
Error Messages and Codes
23,0XX.6x, 26,0XX.6x
Yes No
Go to Step 2. Complete.
Reset NVRAM. If the Reconnect the sys-
error persists, tem grounds.
replace the NVRAM
device (REP 5.0.9).

26,0XX.6x Printing Faults

A printing process error has occurred. The following troubleshooting procedure applies to
these errors:
Printing Faults
26,0xx.6x A printing process fault occurred during operation.
26,962.64 A fall out code fault.
Initial Actions
• Reset NVRAM and retest.
• If the problem persists, follow the procedure below.
Troubleshooting Procedure
Check the fault history and troubleshoot the error listed immediately prior to these codes. Oth-
erwise, reboot the system to clear these error conditions.
10/2006
2-34
Initial Issue
Phaser 8510/8560MFP Multifunction Product