Xerox Phaser 8560MFP Service Documentation page 127

Figure 2 Removing the Ink Loader
6. Disconnect the Ink Loader Power harness P/J5 from the Electronics Module.
7. Remove the Ink Loader harness from the retaining clip on the right side, and then discon-
nect the harness P/J0150 from the Ink Loader to remove the Ink Loader.
Replacement
Perform these steps while replacing the Ink Loader Assembly.
1. Raise the Media Path Elevator before inserting the assembly.
Initial Issue
Phaser 8510/8560MFP Multifunction Product
2. Secure the Ink Loader harness in the retainer clip provided on the Ink Loader, and con-
nect P/J0150.
3. Route the Ink Loader Power harness towards the left side and connect P/J5.
4. Transfer the Ink Sticks to the replacement Ink Loader.
10/2006
4-13
Repairs and Adjustments
REP 2.0.1