Xerox Phaser 8560MFP Service Documentation page 130

Figure 4 X-Axis Bias Spring Hook
11. Disconnect the Air Hose from the Purge Pump.
12. Remove the left and right Printhead Restraints. To remove the restraints, remove 1 (plas-
tic, T-20) screw that secures each restraint, and then shift the restraint inwards toward the
Printhead while lifting toward the rear of the printer.
Repairs and Adjustments
REP 2.0.2
Figure 5 Removing the Printhead Restraint Screws
NOTE: Adjust the Printhead along its X-Axis as needed using a small screwdriver
inserted in the slot on the X-Axis Motor to allow removal of the Printhead Restraints.
Figure 6 Removing the Printhead Restraints
13. Remove the Roll Block on the left end of the Printhead Shaft.
10/2006
4-16
Initial Issue
Phaser 8510/8560MFP Multifunction Product