Adj 2.2.1 Printhead Parking - Xerox Phaser 8560MFP Service Documentation

NOTE: Make sure the Scanner Calibration page is aligned correctly and the paper guides
are adjusted to fit against the paper. If the page is misaligned, the calibration procedure
fails.
11. Select Document Feeder Step from the menu, and then press Enter to scan the Calibra-
tion page.
12. When the scan completes, check the control panel message:
• If the Control Panel indicates Success, select Continue, press Enter, and calibration
procedure is complete.
• If the Control Panel indicates Failure, select Continue, press Enter, and then repeat
Steps 1 and 2 until a successful result is achieved.
Initial Issue
Phaser 8510/8560MFP Multifunction Product

ADJ 2.2.1 Printhead Parking

Purpose
To place the Printhead in a parked position, away from the Drum, during service procedures or
when the Control Panel parking routine is unavailable.
After servicing the system, place the Printhead, Head Tilt Gear, Printhead Wiper Blade, and
Process Drive in their home positions before turning the system power on. Damage to the Pro-
cess Drive or system errors can result during system initialization.
Adjustment
Use this procedure to move the Printhead to its parked position.
1. Remove the Scanner Assembly with attached DADF (REP 1.0.11).
2. Remove the Output Tray (REP 1.0.6).
3. Remove the Left Side Cover (REP 1.0.7).
4. Remove the Right Side Cover (REP 1.0.21).
5. Remove the Ink Loader (REP 2.0.1).
6. Engage the Head Tilt Gear as shown in Figure 1.
10/2006
4-71
CAUTION
Repairs and Adjustments
ADJ 1.15.1, ADJ 2.2.1