Xerox Phaser 8560MFP Service Documentation page 169

Figure 2 Removing the X-Axis Spring Retainer
6. Unlock the Wiper Blade and raise the Wiper Blade to the top of its travel.
7. Raise the Exit Elevator.
8. Remove the Waste Tray Cover without disconnecting the Waste Tray Sensor harness.
a. Lift the center of the cover to release the right side hook.
b. Move the cover towards the back to release the 2 tabs from the chassis.
c. Pull the cover right to release the left hook and position the cover out of the way.
Figure 3 Removing the Waste Tray Cover
Initial Issue
Phaser 8510/8560MFP Multifunction Product
9. Reach into the Waste Tray cavity and pull the gear and shaft from the chassis.
Replacement
The leaf spring on the back side of the chassis must be behind the gear to engage. Lubricate
the curved surface of the gear using a small amount of Rheolube 768 grease (P/N
070E00890).
1. Remove the Leaf Spring from the chassis.
2. Partially insert the Head Tilt Gear Shaft into the chassis.
Figure 4 Replacing the Head Tilt Gear
3. Replace the spring. Turn the Head Tilt Gear while inserting the spring to guide the spring
to its proper position behind the gear.
10/2006
4-55
Repairs and Adjustments
REP 4.0.16