Scanner - Toshiba e-STUDIO2330C Service Manual

24.7 Scanner

Classific
Code
ation
305 Scanner Image location adjustment
of secondary scanning
direction
(scanner section)
306 Scanner Image location adjustment
of secondary scanning
direction
(scanner section)
308 Scanner Distortion mode
340 Scanner Reproduction ratio
adjustment of secondary
scanning direction
(scanner section)
349 Scanner Shading correction plate
Automatic dust detection
adjustment
350 Scanner Shading
position
adjustment
351
354 RADF Adjustment of
RADF paper
alignment
355
357 RADF Fine adjustment of RADF
transport speed
358 RADF RADF sideways deviation
adjustment
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Adjustment mode (05)
Functi <Accept
Items
on
ALL
<68-188>
ALL
ALL
ALL
ALL
Original ALL
glass <68-188>
RADF ALL
<68-188>
for single ALL
sided
original
for double ALL
sided
original
ALL
ALL
24 - 57
Default
RAM Contents
able
value>
124 SYS When the value
increases by "1", the
image shifts by approx.
0.08333 mm toward the
trailing edge of the
paper.
113 SYS When the value
<0-255> increases by "1", the
image shifts by approx.
0.0423 mm toward the
front side of the paper.
- - Moves carriages to the
adjusting position.
(Ch.8.5.9)
128 SYS When the value
<0-255> increases by "1", the
reproduction ratio in the
secondary scanning
direction (vertical to
paper feeding direction)
increases by approx.
0.017%.
- -
117 SYS 0.08333 mm/step
133 SYS 0.08333 mm/step
10 SYS When the value
<0-20> increases by "1", the
aligning amount
increases by approx.
0.4 mm.
10 SYS When the value
<0-20> increases by "1", the
aligning amount
increases by approx.
0.5 mm.
50 SYS When the value
<0-100> increases by "1", the
reproduction ratio of the
secondary scanning
direction on original (fed
from the RADF)
increases by approx.
0.1%.
128 SYS When the value
<0-255> increases by "1", the
image of original fed
from the RADF shifts
toward the rear side of
paper by approx.
0.0423 mm.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
Proce
dure
1
1
6
1
6
1
1
1
1
1
1
ADJUSTMENT MODE (05)
24