Disassembly And Replacement - Toshiba e-STUDIO2330C Service Manual

16.6 Disassembly and Replacement

16.6.1 Fuser unit
Notes:
• Be sure that the temperature of the fuser unit has lowered enough before taking it off. If the
unit still heated should be taken off, wear a pair of gloves before working.
• When a new fuser unit is installed, be sure to check whether the fuser-related life counter
values have been cleared in the list printing mode, PM supporting mode or the setting mode
(08).
(1) Open the automatic duplexing unit (ADU)
and 2nd transfer unit (TRU).
(2) Loosen 2 screws, and then take off the fuser
unit.
Note:
The fuser unit is extremely hot. When taking
off the fuser unit, hold the handles of the unit
to avoid a direct touch on the unit.
Notes:
Follow the procedure below for the
installation.
1. Insert the fuser unit into the equipment
and tighten the screws. At this time, turn
the handle to engage the gears of the
equipment and the fuser unit.
2. Fix the 2 screws securely.
3. Check that they are engaged properly by
turning the handle.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Fuser unit
Fig. 16-8
Fuser unit
Fig. 16-9
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
16 - 17
Handle
FUSER UNIT / PAPER EXIT SECTION
16