Pressure Roller Cover - Toshiba e-STUDIO2330C Service Manual

16.6.5

Pressure roller cover

(1) Take off the fuser unit.
P.16-17 "16.6.1 Fuser unit"
(2) Remove 3 screws (those on the center
section and the rear section are shoulder
screws), and then take off the pressure roller
cover.
Note:
When installing, be sure to push the
harnesses in the direction of the arrows so
that they do not get caught in the pressure
roller cover.
16.6.6 Transport guide
(1) Take off the rear side cover.
P.16-18 "16.6.3 Rear side cover"
(2) Release the harness out of the clamp, and
then disconnect 1 relay connector.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Shoulder screw
Fig. 16-13
Fig. 16-14
Fig. 16-15
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
16 - 19
Pressure roller cover
Relay connector
FUSER UNIT / PAPER EXIT SECTION
16