(5)
Remove a spring and an E-ring, and then
take off the fuser belt front thermistor
bracket.
Notes:
Pay attention to the following points when
installing the fuser belt front thermistor
bracket.
•
The fuser belt and the temperature
sensor in the fuser belt front thermistor
are not damaged.
•
The temperature sensor in the fuser belt
front thermistor contacts with the heat
roller.
•
The fuser belt front thermistor bracket
moves smoothly.
(6)
Remove 1 screw and take off the fuser belt
front thermistor.
16.6.16 Exit sensor (S26)
(1)
Take off the fuser unit.
P.16-17 "16.6.1 Fuser unit"
(2)
Open the jam access cover.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
FUSER UNIT / PAPER EXIT SECTION
Fuser belt
front thermistor bracket
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
16 - 38
Fig. 16-66
Fuser belt
front thermistor bracket
Fig. 16-67
Fig. 16-68