Nd Transfer Facing Roller / 2Nd Transfer Facing Roller Cleaning Mylar - Toshiba e-STUDIO2330C Service Manual

14.6.7 2nd transfer facing roller / 2nd transfer facing roller cleaning
mylar
(1) Take off the transfer belt.
 P.14-16 "14.6.4 Transfer belt"
(2) Remove 2 screws, and then take off the 2nd
transfer facing roller front holder. Then take
off the 2nd transfer facing roller and 1
bearing.
Note:
Be sure not to damage the earth plate of 2nd
transfer facing roller rear holder.
(3) Peel the 2nd transfer facing roller cleaning
mylar.
Note:
Attach the 2nd transfer facing roller cleaning
mylar to the position shown in the figure
within the error of 0.5 mm or less (by slightly
pushing it to the 2 edges of the 2nd transfer
facing roller cleaning holder in the direction
of the arrow).
Note:
Never attempt to loosen the 2 red screws
shown in the figure.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
TRANSFER UNIT
Bearing
2nd transfer facing roller
2nd transfer facing roller front holder
Holder
Mylar
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
14 - 20
Bearing
Fig. 14-30
2nd transfer facing roller
cleaning mylar
Fig. 14-31
Fig. 14-32