Error Code And Troubleshooting - Toshiba e-STUDIO2330C Service Manual

26. ERROR CODE AND TROUBLESHOOTING

26.1 General Descriptions
This chapter explains the procedures for solving troubles occurring in the equipment.
When a trouble occurs, check if an error code is displayed on the LCD screen of the control panel first.
If displayed, refer to"26.2Error Code List" to figure out the classification and contents of the error, and
then refer to "26.3Diagnosis and Prescription for Each Error Code" to remove its cause.
If not displayed and the equipment does not operate properly or images are not printed properly, refer
to "26.4Other errors" or "26.5Troubleshooting for the Image" to remove its cause.
Note:
If unusual odor is detected or if smoke or fire comes out of the equipment, immediately turn the power
OFF.
Even in the cases other than the above, fully observe safety precautions.
If any PC board or HDD shall be replaced, refer to"21.3Precautions for Installation of GP-1070 and
26
Disposal of HDD/Board".
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
ERROR CODE AND TROUBLESHOOTING
26 - 1