Drum - Toshiba e-STUDIO2330C Service Manual

12.6.8

Drum

(1) Take off the main charger assembly.
 P.12-15 "12.6.4 Main charger assembly"
(2) Release the 2 latches, and then take off the
bushing.
(3) Pull out the shaft from the rear side, then
hold the gear part of the drum and take it off.
Notes:
• Be sure not to lose the sleeve which will
remain on the shaft or rear side of the
drum.
• Be sure not to lose the bearing installed
on the frame.
• Be sure not to touch, spit or scratch on
the drum surface.
• Avoid a direct sunlight onto the drum.
Move it to a dark place as soon as it is
taken off.
• Be sure not to touch or scratch the edge
of the drum cleaning blade.
Note:
When the retainer installed on the drum shaft
has been taken off, be sure to install it while
aligning the direction of the ribs of the
coupling with the pin on the drum shaft.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
PROCESS UNIT RELATED SECTION
Bushing
Drum
Bearing
Retainer
Pin
Drum shaft
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
12 - 18
Latch
Fig. 12-26
Shaft
Sleeve
Fig. 12-27
Rib
Coupling
Fig. 12-28