Scanner - Toshiba e-STUDIO6520C Service Handbook

2.5.6

Scanner

Classific
Code
ation
305 Scanner Image location adjustment
of secondary scanning
direction
(scanner section)
306 Scanner Image location adjustment
of secondary scanning
direction
(scanner section)
308 Scanner Distortion mode
340 Scanner Reproduction ratio
adjustment of secondary
scanning direction
(scanner section)
352 RADF EEPROM initialization
353 RADF original reading start
sensor Manual adjustment
356 RADF Automatic adjustment of
RADF original reading start
sensor
357 RADF Fine adjustment of RADF
transport speed
358 RADF RADF sideways deviation
adjustment
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
Adjustment mode (05)
Functi <Accept
Items
on
ALL
<68-188>
ALL
<0-255>
ALL
ALL
<0-255>
ALL
ALL
ALL
ALL
<0-100>
ALL
<0-255>
2 - 85
Default
RAM Contents
able
value>
124 SYS When the value
increases by "1", the
image shifts by approx.
0.09 mm toward the
trailing edge of the
paper.
113 SYS When the value
increases by "1", the
image shifts by approx.
0.0423 mm toward the
front side of the paper.
- - Moves carriages to the
adjusting position.
128 SYS When the value
increases by "1", the
reproduction ratio in the
secondary scanning
direction (vertical to
paper feeding direction)
increases by approx.
0.025%.
- - Initializes EEPROM for
the RADF.
- - Adjusts the RADF
original reading start
sensor of the RADF
manually.
- SYS Performs the
adjustment and
initialization when the
RADF board or RADF
original reading start
sensor is replaced.
50 SYS When the value
increases by "1", the
reproduction ratio of the
secondary scanning
direction on original (fed
from the RADF)
increases by approx.
0.1%.
128 SYS When the value
increases by "1", the
image of original fed
from the RADF shifts
toward the rear side of
paper by approx.
0.0423 mm.
e-STUDIO5520C/6520C/6530C
Proce
dure
1
1
6
1
6
6
6
1
1
SELF-DIAGNOSTIC MODE
2