(5)
Loosen 2 pressure screws, and then remove
2 springs.
Note:
When installing, tighten the 2 pressure
screws securely until they are no longer
moved.
(6)
Loosen 1 screw, and then slide the bracket to
unfix the pressure roller lamp.
(7)
Slide the pressure roller lamp to the rear side
to take it off from the front bracket. Then take
off the pressure roller by lifting it up.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
FUSER UNIT / PAPER EXIT SECTION
Pressure screw
Pressure roller lamp
Bracket
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
16 - 22
Spring
Fig. 16-22
Bracket
Pressure roller lamp
Fig. 16-23
Pressure roller
Fig. 16-24