Tray Drive Unit - Toshiba e-STUDIO2330C Service Manual

11.6.22 Tray drive unit

(1) Remove the upper and lower drawers.
(2) Take off the filter bracket.
 P.21-8 "21.1.10 FIL board"
(3) Disconnect 1 connector. Remove 4 screws
and take off the tray drive unit with the
bracket.
11.6.23 2nd drawer transport clutch (Low speed) (CLT4)
(1) Take off the tray drive unit.
 P.11-29 "11.6.22 Tray drive unit"
(2) Disconnect 1 connector and remove 1 clip to
take off the 2nd drawer transport clutch (low
speed).
Note:
When assembling the clutch, match the
protruded portion of the clutch with the
position shown in the figure.
11.6.24 2nd drawer transport clutch (High speed) (CLT5)
(1) Take off the tray drive unit.
 P.11-29 "11.6.22 Tray drive unit"
(2) Disconnect 1 connector and remove 2
screws to take off the whole set of the clutch.
(3) Take off the bracket, shaft, gear and 2
bushings.
Note:
When assembling the clutch, match the
protruded portion of the clutch with the
position shown in the figure.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Tray drive unit
Fig. 11-53
2nd drawer transport clutch ( Low speed )
Fig. 11-54
2nd drawer transport clutch ( High speed )
Fig. 11-55
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
11 - 29
PAPER FEEDING SYSTEM
11