Fuser Belt Center Thermostat (Thmo1) - Toshiba e-STUDIO2330C Service Manual

Notes:
When installing the thermistors, be sure not
to deform them. Check the gap between the
thermistors and the pressure roller while they
are being pushed each other in the following
procedure:
1. Take off the separation finger unit.
 P.16-20 "16.6.7 Separation finger unit
/ Separation finger"
2. Check that the gap between the pressure
roller rear thermistor and the pressure
roller is 1.5 - 2.5 mm through the opening.
3. Check that the gap between the pressure
roller center thermistor and the pressure
roller is 1.5 - 2.5 mm through the opening.

16.6.13 Fuser belt center thermostat (THMO1)

(1) Take off the front side cover, pressure roller
cover and transport guide.
 P.16-18 "16.6.2 Front side cover"
 P.16-18 "16.6.4 Heat roller cover"
 P.16-19 "16.6.6 Transport guide"
(2) Release the harness out of 1 terminals of the
fuser belt center thermostat.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
FUSER UNIT / PAPER EXIT SECTION
Pressure roller
center thermistor ( THM4 )
1.5~2.5 mm
Pressure roller
Pressure roller
rear thermistor ( THM4 )
1.5~2.5 mm
Pressure roller
Harness
Fuser belt center thermostat
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
16 - 34
Fig. 16-54
Fig. 16-55
Fig. 16-56