Poor Image Density, Color Reproduction And Gray Balance - Toshiba e-STUDIO2330C Service Manual

26.5.3

Poor image density, color reproduction and gray balance

Check gray balance.
Check color reproduction.
Cause/Section Step
Density / Color 1
reproduction /
Gray balance
Printer density 2
Scanner 3
Parameter 4
adjustment value
Printer output 5
image abnormal
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
ERROR CODE AND TROUBLESHOOTING
Fig. 26-2
Check items
Check the image density / color
reproduction / gray balance.
Check the density of printer output
image.
Check if the original glass, mirrors
or lens is dirty.
Check the image processing
parameters.
Is there any faded image (low
density)?
Is there any fog in the background? Perform the troubleshooting
Is there any blotch image?
Is there any poor transfer?
Is there any poor cleaning of the
transfer belt? (Check inside the
equipment.)
26 - 126
Check image density.
Check color reproduction.
Measures
Perform the enforced performing of
image quality closed-loop control
(05-395) and then automatic
gamma adjustment.
Output the test patterns and check
them.
Color: using 04-231 for each color
Black: using 04-113
Clean it.
Adjust the color balance (color).
Adjust the image density.
Perform the troubleshooting
procedures against the faded
image.
procedures against the background
fogging.
Perform the troubleshooting
procedures against the blotch
image.
Perform the troubleshooting
procedures against the poor
transfer.
Correct the transfer belt area.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Remarks
See step 5
if defect
occurs.