Paper Dust Holder - Toshiba e-STUDIO2330C Service Manual

(7) Remove each 1 screw fixing the both front
and rear holders.
(8) Remove 2 clips, and then move the front and
rear holders and bushings to the inner side.
(9) Move the registration roller (metal) to the rear
side, and then take it off from the front side.

11.6.36 Paper dust holder

(1) Take off the registration roller (metal).
 P.11-37 "11.6.35 Registration roller
(Metal)"
(2) Remove 2 screws, and then take off the
paper dust holder.
11.6.37 1st drawer transport clutch (Low speed) (CLT2)
(1) Open the board case.
 P.21-10 "21.1.11 Board case"
(2) Remove 2 screws and take off the bracket.
(3) Disconnect 1 connector and take off the 1st
drawer transport clutch (Low speed).
Note:
When assembling the clutch, match the
protruded portion of the clutch with the
position shown in the figure.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Registration roller ( Metal )
Fig. 11-82
Fig. 11-83
1st drawer transport clutch ( Low speed )
Fig. 11-84
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
11 - 39
Paper dust holder
PAPER FEEDING SYSTEM
11