Toner Motor Assembly - Toshiba e-STUDIO2330C Service Manual

13.5.18 Toner motor assembly

Dedicated toner motors and toner cartridge detection sensors which correspond to the process units
(EPU (Y, M, C, K)) respectively are installed.
• Process unit (EPU (Y)): Toner motor (M2), Toner cartridge detection sensor (S8)
• Process unit (EPU (M)): Toner motor (M3), Toner cartridge detection sensor (S9)
• Process unit (EPU (C)): Toner motor (M4), Toner cartridge detection sensor (S10)
• Process unit (EPU (K)): Toner motor (M5), Toner cartridge detection sensor (S11)
Take off the corresponding toner motor assembly.
(1) Take off the tray back cover and transfer belt
cleaning unit.
 P.3-27 "3.5.3 Tray back cover"
 P.14-11 "14.6.1 Transfer belt cleaning
unit"
(2) Remove 2 screws and slide the toner cover
to take it off.
Note:
When installing, make sure that 4 hooks are
secured.
(3) Remove 2 screws and take off the toner
supply section.
Note:
Remove the toner supply section by turning it
so that its notch and the rib of the toner
transport gear are engaged.
Be careful not to scatter the toner inside the
toner supply section.
(4) Remove 1 clamp, and then disconnect 1
relay connector.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 13-61
Toner supply section
Fig. 13-62
Clamp
Connector
Fig. 13-63
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
13 - 31
Toner cover
DEVELOPER UNIT
13