Toshiba e-STUDIO2330C Service Manual page 635

• PM support mode (6S):
<Operation procedure>
[6][START]
[POWER]
2: PM Support Screen
• Firmware update mode (89): Refer to "20.FIRMWARE UPDATING".
• State transition diagram of self-diagnosis modes
Normal
[0][1]
Control panel
Warming up
check mode
Ready
[POWER]
OFF
*1
To user
*1 Turn OFF the power after using the self-diagnosis mode, and leave the equipment to the user.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
(Code) [START]
(Operation started)
[POWER]
ON
[0][3] [0][4] [0][5]
Adjustment
Test print
Test mode
mode
mode
State transition diagram of self-diagnosis modes
Fig. 23-1
23 - 3
[POWER] OFF/ON
(Exit)
[0][8] [9][START] [6][START]
Setting List print PM support
mode
mode mode
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
SELF-DIAGNOSTIC MODE
23
[8][9]
Firmware
update mode