Toshiba e-STUDIO2330C Service Manual page 440

(3) Remove 3 screws and take off the fuser belt
center thermostat.
Notes:
• When installing them, fix the thermostat,
and then fix the terminal of the harness.
• Check that the gap between the fuser belt
center thermostat and the fuser belt is 1.6
- 2.2 mm while they are being pushed
each other, through the opening.
Note:
When installing, be careful not to insert the
tab terminal between the insulating tube and
the terminal.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Fuser belt
center thermostat
Fig. 16-57
Fuser belt center
thermostat ( THMO1 )
Fuser belt
1.6 mm to 2.2 mm
Fig. 16-58
Harness
Fig. 16-59
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
16 - 35
Insulating tube
Terminal
Tab terminal
FUSER UNIT / PAPER EXIT SECTION
16