Auto-Toner Sensor (S22, S23, S24, S25) - Toshiba e-STUDIO2330C Service Manual

13.5.5

Auto-toner sensor (S22, S23, S24, S25)

The auto-toner sensors are installed in the process units (EPU (Y, M, C, K)).
• Process unit (EPU (Y)): Auto-toner sensor (S22)
• Process unit (EPU (M)): Auto-toner sensor (S23)
• Process unit (EPU (C)): Auto-toner sensor (S24)
• Process unit (EPU (K)): Auto-toner sensor (S25)
(1) Take off the corresponding the process unit
(EPU), and then take off the developer unit to
remove the developer material out of the
unit.
 P.12-12 "12.6.1 Process unit (EPU)"
 P.12-15 "12.6.3 Cleaning unit/ Developer
unit"
 P.13-13 "13.5.3 Developer material"
(2) Remove 2 screws, and take off the duct.
(3) Disconnect the connector.
(4) Hold the locking part to lift it up, and then turn
the auto-toner sensor counterclockwise for
90 degrees to take it off.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Duct
Fig. 13-31
Connector
Fig. 13-32
Locking part
Fig. 13-33
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
13 - 19
Auto-toner sensor
DEVELOPER UNIT
13