St Transfer Roller Cam Motor (M8) - Toshiba e-STUDIO2330C Service Manual

14.6.9

1st transfer roller cam motor (M8)

(1) Take off the transfer belt.
 P.14-16 "14.6.4 Transfer belt"
(2) Remove 2 E-rings, and then take off the idler
roller. Then take off the 2 bushings and 2
bearings.
Note:
Be careful not to deform the earth plate of
the tension roller arm on the front side.
(3) Remove 3 E-rings, and then slide the 3
bushings of the cam shaft.
(4) Remove 2 screws, and then take off the TBU
brush bracket.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
TRANSFER UNIT
Bearing
Bushing
Bushing
TBU brush bracket
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
14 - 22
Bushing
Bearing
Idler roller
Fig. 14-35
Fig. 14-36
Fig. 14-37