Toshiba e-STUDIO2330C Service Manual page 1052

[CC61] Punch motor (M3) home position detection error
* The [CC61] error will be displays when the [E9F0] error occurs three times in succession or
during the initial operation.
MJ-1101 (When MJ-6101 is installed)
Is there any paper remaining on the transport path?
YES
Remove the paper.

NO
Rotate the punch motor (M3). Does it rotate smoothly?
NO
 Fix the mechanism.
YES
Are the punch home position sensor (S4) and its wiring correct?
NO
 Replace the sensor. Correct the wiring.
YES
Is the wiring between the hole punch control PC board (HP) and punch motor (M3) correct?
NO
Correct the wiring.

YES
1. Replace the punch motor (M3).
2. Replace the hole punch control PC board (HP).
[CC71] Punch ROM checksum error
MJ-1101 (When MJ-6101 is installed)
Is the conductor pattern on the hole punch control PC board (HP) open circuited or short
circuited?
YES
 Replace the hole punch control PC board (HP).
NO
Replace the finisher control PC board.
[CC72] Punch RAM read/write error
MJ-1101 (When MJ-6101 is installed)
Is the conductor pattern on the hole punch control PC board (HP) open circuited or short
circuited?
YES
Replace the hole punch control PC board (HP).

NO
Replace the finisher control PC board.
[CC80] Front jogging motor abnormality/Front aligning plate motor abnormality
MJ-1030 (Front aligning plate motor abnormality)
Is the front aligning plate home position sensor (PI36) normal?
 NO 
Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the front aligning plate motor (M33)
correct?
 NO 
Correct the wiring.
YES
Is there any mechanical problem with the path of aligning plate?
 NO 
Fix the mechanism.
YES
1. Replace the front aligning plate motor.
2. Replace the finisher controller PC board.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
ERROR CODE AND TROUBLESHOOTING
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
26 - 82