Shutter Motor (M12) - Toshiba e-STUDIO2330C Service Manual

(9) Remove 2 screws, slide the shutter unit to
the front, and then pull it out to the exit side.
9.4.3

Shutter motor (M12)

(1) Take off the shutter unit.
 P.9-14 "9.4.2 Shutter unit"
(2) Disconnect 1 connector, release 2 clamps,
remove 3 screws and take off the shutter
motor with the bracket.
(3) Remove the E-ring. Then remove 1 gear, 1
spring and 1 polyslider.
Note:
When assembling the unit, be sure to install
the polyslider.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Shutter unit
Fig. 9-24
Shutter motor
Fig. 9-25
Fig. 9-26
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
9 - 15
Gear
Spring
Polyslider
LASER OPTICAL UNIT
9