Maximum Toner Density Adjustment - Toshiba e-STUDIO2330C Service Manual

8.7.6

Maximum toner density adjustment

The maximum toner amount adhering to the paper can be controlled.
Code Paper type
1050 OHP film
<Procedure>
The procedure is the same as that of  P.8-57 "8.7.4 Adjustment of faint text".
Note:
The larger the value is, the more frequently fusing offsetting occurs.
8.7.7 Fine line enhancement switchover
Black mode
PS PCL XPS
7322-0 7322-1 7322-2
<Procedure>
The procedure is the same as that of  P.8-54 "8.7.2 Gamma balance adjustment (Black Mode)".
8.7.8 "PureBlack/PureGray" threshold adjustment (PCL)
Original mode
Photograp
General
hic
8210-0 8210-1
8211-0 8211-1
8212-0 8212-1
<Procedure>
The procedure is the same as that of  P.8-54 "8.7.2 Gamma balance adjustment (Black Mode)".
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
IMAGE PROCESSING
The smaller the value is, the toner amount adhered decreases of the high
density area (ex. prevention of fusing offsetting, etc.).
Acceptable values: 0 to 255
(Default: OHP film: 200)
Color mode
PS PCL
8102-0 8102-1 8102-2
Presentati
Line art
on
8210-2 8210-3
8211-2 8211-3
8212-2 8212-3
8 - 58
Remarks
Remarks
Whether fine lines are enhanced or not can be
switched.
0: OFF
1: ON
Acceptable values: 0 to 1 (Default: 1)
Item to be
adjusted
Text The larger the value is, the wider the
color range to be printed only with the
Graphics
black toner becomes. The smaller the
value is, the narrower this color range
Image
becomes. Acceptable values: 1 to 255
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
<Adjustment Mode (05)>
<Adjustment Mode (05)>
<Adjustment Mode (05)>
Remarks