Adjusting The Tension Of The Stack Processing Motor Belt - Toshiba e-studio200l Service Handbook

3.12.4

Adjusting the tension of the stack processing motor belt

<Procedure>
(1) Remove the right inner cover and the rear cover.
(2) Remove the 2 mounting screws, and detach
the grip unit.
(3) Loosen the screw on the tension arm plate.
(The tension arm plate will be pulled under
tension by the tension spring.)
(4) Move the returning roller shaft to its lower
limit (the slack of a belt is lightly taken); then,
tighten the screw on the tension arm plate.
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
Screw
Fig. 3-118
Screw
Tension arm
plate
Fig. 3-119
Screw
Tension arm
plate
Fig. 3-120
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
3 - 89
Grip unit
Screw
Returning
roller shaft
ADJUSTMENT
3