Defaults
4
Command
ROUTER OSPF for OSPFv2
Modes
ROUTER OSPFv3 for OSPFv3
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.1(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
network area
Define which interfaces run OSPF and the OSPF area for those interfaces.
S4810
Syntax
network ip-address mask area area-id
To disable an OSPF area, use the no network ip-address mask area area-
id command.
Parameters
ip-address
mask
area-id
1178
Introduced on the S6000.
Introduced support for OSPFv3 on the S4810 and Z9000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Specify a primary or secondary address in dotted decimal
format. The primary address is required before adding the
secondary address.
Enter a network mask in /prefix format. (/x)
Enter the OSPF area ID as either a decimal value or in a valid
IP address. Decimal value range is from 0 to 65535. IP
address format is dotted decimal format A.B.C.D.
NOTE: If the area ID is smaller than 65535, it is converted
to a decimal value. For example, if you use an area ID of
0.0.0.1, it is converted to 1.
Open Shortest Path First (OSPFv2 and OSPFv3)