Log-Adjacency-Changes - Dell S4810 Reference Manual

log-adjacency-changes

To send a Syslog message about changes in the OSPF adjacency state, set Dell Networking OS.
S4810
Syntax
log-adjacency-changes
To disable the Syslog messages, use the no log-adjacency-changes
command.
Defaults Disabled.
Command ROUTER OSPF
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
maximum-paths
Enable the software to forward packets over multiple paths.
S4810
Syntax
maximum-paths number
To disable packet forwarding over multiple paths, use the no maximum-paths
command.
Parameters
number
Open Shortest Path First (OSPFv2 and OSPFv3)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Specify the number of paths. The range for OSPFv2 is from 1
to 64. The default for OSPFv2 is 4 paths. The range for
OSPFv3 is from 1 to 64. The default for OSPFv3 is 8 paths.
1177